What Is The Design Of The LED Power Supply?

- Sep 03, 2018 -

What is the design of the LED power supply?

 

24v Led Driver Dimmable.jpgLED driver power supply design is not difficult, but it must be known. As long as the calculation before commissioning, measurement during commissioning, and aging after commissioning, I believe anyone can do a good job of LED. The power consumption of the power tube is divided into two parts, switching loss and conduction loss. For LED mains drive applications, the switching damage is much greater than the conduction loss. The switching loss is related to the cgd and cgs of the power tube and the driving capability and operating frequency of the chip. Therefore, to solve the heat generation of the power tube, it can be solved from the following aspects.


The MOS power transistor cannot be selected one-sidedly according to the on-resistance, because the smaller the internal resistance, the larger the cgs and cgd capacitance. The rest is the frequency and chip drive capability, here only the frequency effect. The frequency is also proportional to the conduction loss. Therefore, when the power tube is hot, the first thing to think about is whether the frequency selection is a bit high. When the frequency is reduced, in order to obtain the same load capacity, the peak current must be increased or the inductance is also increased, which may cause the inductor to enter the saturation region. If the inductor saturation current is large enough, consider changing the CCM to DCM, which requires adding a load capacitor.


In view of the high-power LED operating voltage of only 3V, 220V AC is converted to DC by full-bridge rectification, the voltage drop across the bridge is about 1.8V, and the power utilization efficiency of driving only one LED is only 60%. More than three LEDs must be connected in series to achieve a total power utilization efficiency of more than 80%. According to the principle of 3 primary color synthetic white light, three 1W high-power LEDs of red, green and blue are connected in series, and the brightness achieved by the LED equivalent to 3W white light can be obtained. At the same time, it can also combine 6 kinds of colored light to satisfy people's preference for changing color light.



Related News

Related Products

  • Constant Led Driver
  • Led Strip Power Supply 12v
  • Led Driver 50w
  • 700ma Constant Current Led Driver Dimmable
  • 12v 5a Switching Power Supply
  • Constant Voltage 200 Watt Led Driver