24v Dc Dimmable Led Driver 100w
The 100 watt IP67 Smart transformer (SMT-024-096VT and SMT-012-096VT) is a premium Smart-branded power driver, which means it is built to last and fully tested for reliability. We can supply this LED transformer in both 12v and 24v versions, and it has no minimum load.
24v dc dimmable led driver 100w
The 100 watt IP67 Smart transformer (SMT-024-096VT and SMT-012-096VT) is a premium Smart-branded power driver, which means it is built to last and fully tested for reliability. We can supply this LED transformer in both 12v and 24v versions, and it has no minimum load. The unit can power any of our LED tapes – up to 100 watts, as long as the tape’s voltage matches the voltage of the transformer. This transformer unit is fully enclosed – so it’s safe to touch and can be installed in most locations. To hook up the transformer, you can link it directly into a 240v supply. We have test that the driver can match well with Lutron brand dimmer, so if your project use Lutron dimmer then you can choose our dimmable led driver.
100~130V AC/170～265V AC
Power Factor ( Typ.）
Full Load Efficiency(Typ.)
1.48A/110VAC 0.96A/170VAC 0.74A/220VAC 0.62A/265VAC
Hiccup mode, recovers automatically after fault condition
≦140VAC(90~135V) , ≦270VAC(170~265V)
10～500Hz，2G 10min./1 cycle，period for 60min.
each along X,Y,Z axes
EN-60950-1, EN61347-1 EN61347-2-13
I/P-O/P:3.75KVAC I/P-FG:1.88KVAC O/P-FG:0.5KVAC
Compliance toEN55015,EN61000-3-2 (≧50%load)
Compliance to EN55015; EN61000-4-2,3,4,5,6,8,11,EN61547
Alight industry level （surge4KV）
329*279*176mm , 10PCS/ctn
1. All parameters NOT specially mentioned are measured at 110V/230VAC input , rated load and
25℃of ambient temperature.
2. Ripple& noise are measured at 20MHz of bandwidth by using a 12”twisted
pair-wire terminated with a 0.1uf &47uf parallel capacitor.
3. Tolerance:includes set us tolerance,line regulation and load regulation .
Test before you buy
In the domestic and small commercial environment, the lighting specification is very likely to be built around retrofit LED lamps, but the ‘retrofit’ title is becoming a misnomer because there are many new specifications making use of the technology to deliver relatively low-cost installations.
Being designated ‘retrofit’, customers often think that’s all there is to it and will simply swap a tungsten halogen lamp for an LED lamp. It doesn’t help that manufacturers of these LEDs also suggest the same thing on their packaging. But remember that this is an unregulated marketplace, so it’s very important to check that the proposed dimmer works with the selected LED lamp before committing to a specification. Test before you buy.
Although safety standards are still required in the manufacture of the LED because it’s an electrical product, there is no standard based on the performance of an LED. Each manufacturer produces LED products according to their design parameters and comparing two apparently similar products can be a nightmare of dissimilar specification reporting.