Led Lamp Power Supply
No mini load limited
CE ETL FCC ROHS certification
led lamp power supply
For direct wire installations. Simply remove end caps to access on-board terminal block connectors; use NM 18AWG 20CM cable to tie in with 110 120 volt AC line voltage
Uses desirable soft start on and fade off technology
No minimum power load; dimming works equally well whether powering a single 1-watt LED puck light or 24 watts of tape lighting, or a combination of both
Connect up to 100% of the rated 24-watt maximum load – derating performance is not required
Class 2 power supply is intrinsically safe.
NEC Class II AC input requires no ground wire connection.
Safety features include automatic shut-off in case of lighting overload, open circuit, short circuit, over temperature or other fault; the unit will automatically restart after the fault is corrected.
Limited 5-year warranty. Failure to use this power supply for its intended purpose or improper installation will void warranty.
SMARTS Dimmable LED Drivers are compatible with both forward phase (leading edge, triac, incandescent) and reverse phase (electronic lowvoltage, ELV, and trailing edge) AC dimmers, including higher end lighting controls, such as Lutron systems. They are also compatible with low-voltage PWM dimmers.
AC input voltage
24Vdc 1a 24w
CE ETL FCC ROHS approved